SCR功率控制器，用于電氣電阻加熱器

SCR19 and SCR39 Series

^￥3,967.36 SCR19Z-24-040

下單

SCR19 SCR Power Controllers Extend Heater Life Reducing Thermal Shocks
Zero Crossing or Phase Angle Fired
Single or Three Phase Load Switching
No Maintenance All Solid State Components
Close Control of Low Mass Heaters
Phase Angle with Soft Start for High Inrush Heaters
No Relay Noise Contact Arc Noise Eliminated
Semiconductor I2T Fusing
Optically Isolated Control Signal Input

溫度過程控制器和電源開關裝置 - 查看相關產品

產品描述

The SCR19 Series SCR Power Controllers are designed to proportion electric power to resistive loads only, such as ovens, furnaces, heat sealers, etc. (NOTE: They are not designed to drive transformers or any inductive load.)

These heater controllers consist of power semi-conductors (SCRs), properly-sized heat sinks, trigger circuitry, and fuses supplied on panels for surface mounting. The SCR power controller accepts a 4 to 20 mA dc output from a temperature controller or can be supplied with manual option using a remote potentiometer.

The SCR19 Series controllers offers two methods of proportional control – Zero-voltage-switched and Phase-angled-fired. With the Zero-voltage-switching mode, the controller switches on complete cycles of the ac supply voltage. The trigger circuit is designed to turn on the SCRs as close as possible to the point where the AC sine wave crosses through zero. In effect, the line voltage is turned on and off and applied to the heaters in whole cycles.

With an input of 4 to 20 mA, the output of the heter controller will be off below 4 mA and full on at 20 mA. Proportioning action is obtained by varying the number of cycles on to the number of cycles off. The output will vary from one cycle on and nine cycles off at low input, to all cycles on at maximum input.

The output of the SCR19 SCR power controllers is integrated by the heaters which produce a smoothly proportioning heat output that varies directly with the input signal. With the Phase-angle-fired mode, the power to the load is controlled by governing the point of turn on (firing) of each half cycle of the full AC sine wave.

訂購所有價格均為人民幣稅前價格，不包括13%增值稅和運費！(指定型號)

其他客戶同時購買: 這個圖標可以點擊擴大，跳出的清單包括了其他客戶在購買此產品時同時購買的其它產品。

產品編號產品描述

數量

產品描述

SCR19Z-12-040

￥4,027.07

貨期: 11 周

SCR power controller, Zero-Voltage-Switching, 120V, 40A

SCR19Z-24-040

￥3,967.36

貨期: 2 周

SCR power controller, Zero-Voltage-Switching, 240V, 40A

SCR19Z-48-040

￥4,153.13

貨期: 2 周

SCR power controller, Zero-Voltage-Switching, 480V, 40A

SCR19Z-24-060

￥4,093.41

貨期: 2 周

SCR power controller, Zero-Voltage-Switching, 240V, 60A

SCR39Z-24-060

￥7,695.87

貨期: 11 周

SCR power controller, 3-phase, Zero-Voltage-Switching, 240V, 60A

SCR39Z-48-060

￥8,180.17

貨期: 11 周

SCR power controller, 3-phase, Zero-Voltage-Switching, 480V, 60A

SCR19P-24-040-S15

￥4,823.19

貨期: 11 周

SCR power controller, Phase-Angle-Switching, 240V, 40A, 15 sec soft start circuit

SCR19P-24-080-S9

￥5,128.37

貨期: 15 周

SCR power controller, Phase-Angle-Switching, 240V, 80A, 9 sec soft start circuit

Accessories

SCR-210A015U01

￥934.12

貨期: 2 周

Replacement Fuse, 40 A

SCR-210A012U01

￥1,114.59

貨期: 2 周

Replacement Fuse, 60 A

SCR-210A014U01

￥1,034.97

貨期: 2 周

Replacement Fuse, 80 A

SCR19Z-M

￥1,293.72

貨期: 11 周

Manual remote pot for 120V SCR19/39 models

SCR19Z-M-220

￥1,293.72

貨期: 11 周

Manual remote pot for 240V SCR19/39 models

SCR19Z-M-480

咨詢

貨期:

Manual remote pot for 480V SCR19/39 models

按產品編號購買

產品編號

數量

產品編號

數量

† 所有金額以RMB顯示
注: Comes with complete operator’s manual
訂購示例: (1) SCR19Z-24-040 SCR, Zero-Voltage-Switching, 240V, 40A, ￥3,967.36

產品編號生成器

在此處生成您自己的產品編號

	(1)		(2)	(3)	(4)	(5)
SCR		9

選項說明:

(1) Single or 3 Phase 選項:
1 for Single Phase
3 for 3 Phase

(2) Method 選項:
Z for Zero-Voltage Switching
P for Phase-Angle Firing

(3) Voltage 選項:
-02 for 24 Vac for single phase only
-12 for 120 Vac for single phase only
-20 for 208 Vac for phase angle firing
-24 for 240 Vac
-48 for 480 Vac

(4) Current 選項:
-040 for 40 Amps
-060 for 60 Amps
-080 for 80 Amps

(5) Phase-Angle Firing Items 選項:
for Zero-Voltage Switching leave field blank
-S9 for the STANDARD Soft start 9 seconds
-S15 for Soft start 15 seconds
-S30 for Soft start 30 seconds
-S60 for Soft start 60 seconds
-S120 for Soft start 120 seconds
-V for Voltage limit

注: 并非所有組合都有效，請查閱規格表上的有效產品編號。